Spectrum Controls 1734sc-IF4U User Manual
Page 8
1-2
Point IO™ 4 Channel Universal Analog Input Module
User’s Manual Pub. 0300266-01 Rev. A
Section 1.3
Data Formats
For each channel the data can be configured for:
Engineering Units x1
Engineering Units x10
Scaled-for-PID
Raw/proportional counts
Section 1.4
Filter
Frequencies
The module uses a notch filter to provide noise rejection for each input channel. The filter
for each channel is programmable allowing you to select from 4 different filter options:
4.17 Hz
16.7 Hz
62 Hz
470 Hz
Section 1.5
Hardware
Features
Channels are wired as differential inputs.
Module configuration is done via the controller’s programming software. The module
configuration is stored in the memory of the controller. Refer to your controller’s user
manual for more information. The illustration below shows the module’s hardware
features.