SurgeX SX-AX20 - Manual (Page 19)

SX-AX15 (20) Setup and Control Utility User Manual
Page 18
V. Tabs
(continued)
Telnet Server
Use this tab to configure the internal telnet server of the
Axess.
Enable: Use this check box to enable or disable
the telnet server.
Port: Use this field to specify the port the telnet
server will listen on. Numeric values between 1
and 65535 are accepted.
SNMP Agent
Use this tab to configure the internal SNMP agent of
the Axess.
Read Community: Use this field to edit the
read community name. The community name
must contain printable characters only and
cannot exceed 32 characters in length.
Write Community: Use this field to edit the
write community name. The community name
must contain printable characters only and
cannot exceed 32 characters in length.
Select Manager: The Axess can send traps to
up to 4 SNMP managers. Use this combo box
to select one of the 4 managers.
Enable: Use this check box to enable or disable traps to the selected manager.
IP Address: Use this field to set the IP address of the selected SNMP manager.