SurgeX Defender Series Surge + PDU - Manual (Page 2)

Defender Series Surge + PDU User Manual
© SurgeX REV-C Page 2
o SX-DS-IEC-FP
• 230 VAC Single Phase (International)
30A Maximum Capacity
10A Maximum Capacity per Bank
II. Hardware Included
• Tower Configuration Hardware – Option A
• Rack Mount Configuration Hardware – Option B
• Cable Organizing Hardware (optional)
III. Installation
• Warning: Before installing the SurgeX Defender Series unit,
review the safety instructions that came with the unit
Unpack the Unit and Accessories
o Identify each item; refer to the Quick Start Guide for reference
• Connect Cable Organizing Hardware (Optional)
o Use (2) thumbscrews to attach the cable organizer
to the rear panel (figure 1-a)
• Configure Unit
o Select Tower or Rack Mount Configuration
• Determine which configuration is best for your installation
o Option A: For tower installations, the Defender Series
Surge + PDU may be configured to mount upright as a
Tower and can stand on any dry, flat surface
o Option B: For rack installations, the Defender Series
Surge + PDU may be configured to mount within a
standard 19” equipment rack and will require 1 RU (Rack
Unit) of space
o
(1) IEC-60309 332P65 input
power cord
(6) IEC-320 C13 output
power receptacles
(3) 10A Branch Rated
Circuit Breakers
(1) Base stand (6) 6/32 x ½” Flathead Screws
(1) Left
bracket
(1) Right
bracket
(11) 6/32 x ¼”
Flathead Screws
(4) Thumbscrews (4) Cage Nuts
(1) Cable Organizer (2) Thumbscrews (8) Plastic Ties
1-a
2-a 2-b