Tenqa SP-109 User Manual

Page 8

Advertising
background image

6

warning

Failure to follow these safety instructions could result in fire, electric

shock, or other injury or damage.

hanDling the sP-109

Do not drop, disassemble, open, crush, bend, deform, puncture, shred, microwave,

incinerate, paint, or insert foreign objects into the SP-109. Use common sense

when operating this and all electronic devices.

aVoiD water anD wet locations

Do not use the SP-109 in the rain, or near sinks, bathtubs or other wet locations.

Take care not to spill any food or liquid on the SP-109. In case the SP-109 gets

wet, unplug all cables, turn off the SP-109 before cleaning, and allow it to dry

thoroughly before turning it on again. Do not attempt to dry the SP-109 with an

external heat source such as a microwave oven or hair dryer.

rePairing the sP-109

Never attempt to repair or modify the SP-109 yourself. The SP-109 does not contain

any user-serviceable parts. If the SP-109 has been submerged in water, punctured,

or subjected to a severe fall it is advised not to use the device again.

Powering the sP-109

To power the SP-109, use only the power adapter that came with this device.

Read all safety instructions for any products and accessories before using with

the SP-109. Tenqa is not responsible for the operation of third party accessories or

their compliance with safety and regulatory standards.

When using the included power adapter, make sure that the power adapter is fully

connected to the SP-109 before you plug it into a power outlet. Then insert the

SP-109’s power adapter firmly into the power outlet. Do not connect, disconnect,

unplug, or plug in the power adapter with wet hands. The power adapter may

become warm during normal use. Always allow adequate ventilation around the

Tenqa power adapter and use care when handling. Unplug and do not use the

power adapter if any of the following conditions exist:

• The power cord or plug has become frayed or damaged.

• The adapter is exposed to rain, liquid, or excessive moisture.

• The adapter case has become damaged.

• You suspect the adapter needs service or repair.

• You want to clean the adapter.

SP-109_InstructionManual.indd 6

7/1/09 6:28 PM

Advertising