Octave mode. - continued, Tipt p, Midi to cv – Tiptop Z3000 Smzrt VCO User Manual
Page 10
Octave Mode. - Continued
Setting up the Z3000 to use Octave Mode is simple.
First, configure a keyboard through a MIDI to CV
converter and plug the CV output of the converter into
the 1V/OCT input on the Z3000.
Now, set the Z3000 into Octave Mode by pressing the
FREQUENCY/NOTE/OCTAVE button.
Press any low ‘C’ key on the keyboard and use the
FREQUENCY and FINE TUNE knobs to adjust the pitch
of the Z3000 until the desired C note is shown on the
display.
Remember, as the frequency approaches the octave,
the display will show “-Cx” or “Cx-” to show if the
module is below or above the pitch of the actual note.
MIN
MAX
MIN
MAX
LOW
HIGH
SYNC
HSM
1V/Oct
1V/Oct
Linear FM
INPUT
PWM
FM 1
LOW
HIGH
Hz
Oct
FM 2
INPUT
CV IN
INPUT
CV IN
CV OUT
INPUT
INPUT
+
+
+
+
EXT IN
FREQUENCY/NOTE/OCTAVE
Tipt p
A u d i o
Z 3 0 0 0
Z 3 0 0 0
Smart VC-Oscillator
FREQUENCY
FINE TUNE
PULSE WIDTH
PWM
FM
MIDI TO CV