TracRac IM TracRac Toolbox Mount Kit - Manual (Page 4)

994 Jefferson Street, Fall River, MA 02721
Tel: 800-501-1587, 508-677-4130, Fax: 508-677-4136
(REV B) 06/11/02 Page 4 of 4
13) Insert 2 T-Bolts into the slot on each slider, one from each end. Slide the T-Bolts so that each is 6” from the
plastic set screw.
Figure 5
14) Now mount the toolbox, making sure the Plastic Set Screws and T-Bolts protrude through the six holes in your
toolbox.
15) Remove Plastic Set Screws from assembly and immediately replace with the Knobs. Fasten the toolbox to the
sliders with the T-Bolts (in sliders), Flat Washers and Self Locking Nuts to the specified Torque of 240 in/lbs.
(20 ft/lbs.).
16) Now slide the toolbox the length of the Base Rails for final verification. Note: If the toolbox does not slide,
recheck that the Base Rails and Toolbox Mount Sliders are parallel, and that the toolbox is centered.
17) Slide the toolbox towards the cab, making sure you allow clearance to open the lid. Position the Slider Stops
under the toolbox until they butt up against the Toolbox Mounts. Pull the toolbox back and tighten the Set Screws
in the Slider Stops. (The Slider Stops will prevent the toolbox from sliding into the Overhead Racks.)
18) Slide the toolbox up until it butts against the Slider Stops and tighten the toolbox Knobs.
Note: The beds of some newer model trucks taper dramatically, impeding your ability to slide the toolbox entirely
off the tailgate. We recommend utilizing a toolbox with a narrow belly. Measure the width at your truck’s tailgate
to determine the maximum width of your truck bed.
CAUTION: Always make sure the knobs are tightened down to prevent the toolbox from sliding. Be sure to tighten
down the safety screws on the front and rear of the base rails as well.