TracRac IM T-Rac Pro Toolbox Mount - Manual (Page 5)

T-Rac ToolBox Mount Kit INSTRUCTION MANUAL 5 TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 508-677-4130
6. Place the toolbox back onto the mounting clamps. Mark the side of the toolbox where each clamp center is located (re-
member to position the box so the top can open). Take the box off, flip it upside-down and transfer the marks to the “D”
dimension centerlines. Drill 7/16” holes for each clamp location (See Figure 6).
Figure 6. Hole Location Marking
D
Dimension
Transfer marks to intersect
with the “D” dimension.
Drill 7/16” holes (both sides)
Transfer marks to intersect
with the “D” dimension.
Drill 7/16” holes (both sides)
Avoid interference