Treasure Garden GP12120 - Manual (Page 4)

8 3
Optional umbrella base (sold separately)
15
13
12
13
2
12
Knob 12
Vertical Corner (Upright) Post 2
Mounting Plate (2 parts) 13
Base Adaptor Bolt
Plate & Stem Insert
28
Hexagon Wrench (Small) 15
2
Vertical
Adapter
Vertical
Adapter
28
Optional Umbrella Base
Grass Application: If Pavilion is to be
placed on grass, secure with #30 nails
provided. (4 bolts per mounting plate)
Concrete Application: If Pavilion is
to be used placed on concrete, secure
with #29 expansion bolts provided.
(4 bolts per mounting plate)
Expansion
Bolts 29 Nails 30
Loosen the 2 mounting plate screws and remove #13 plate & stem insert (set screws
aside). Tighten #28 base adapter bolt into umbrella base, then slide vertical adapter onto
base adapter bolt and tighten with 2 screws . Finally, slide #2 vertical corner (upright) post
onto vertical adapter and hand tighten knob. Repeat for each umbrella base.
Standard Mounting Set-Up:
Locate and attach #2 vertical
corner (upright) post onto #13
mounting plate. Tighten #12
knob. Repeat for each post.
Mounting and Application Options
Canopy Track Anchor
27
S T E P 9 Secure Roof
Clip canopy track anchors (attached to roof) to each horizontal side beam (5 per
side). Pull each side down along with the fabric corners and on the track anchor to
make the roof tight. Secure with attachment strips. Repeat for each corner.
S T E P 1 0 Attach Ties
Pull corner fabric toward the post, wrap tie around the gathered fabric and secure with
attachment strip. Repeat steps for all corners.
NOTE: Secure mounting plates when Pavilion assembly is complete.
Prepare mounting and set aside for later installation.