Treasure Garden AG3 - Manual (Page 3)

2 5
(Fig. 1) (Fig. 2)
To ATTACH VEGA Umbrella Light:
Loosen the VEGA light adapter built into the umbrella runner by turning counter-clockwise
(Fig. 21). After loosening, pull down light adapter post (Fig. 22) to attach the
VEGA umbrella light (sold separately).
To OPEN and ATTACH VEGA:
Open the VEGA umbrella light by holding firmly with one hand and then depress the clamp
release button with the other hand to release the clamp lock. Open up the VEGA light and
clasp around the light adapter post (Fig. 23). Snap to close (Fig. 24).
To REMOVE VEGA and CLOSE adapter:
Hold the VEGA umbrella light, depress the clamp release button to release the clamp lock.
Remove VEGA umbrella light, and gently push up the light adapter post back into umbrella
runner and tighten turning clockwise (Fig. 21).
(Fig. 21) (Fig. 22)
(Fig. 23) (Fig. 24)
Hex Bolt
Axis
Allen Wrench
Crank
Handle
(Fig. 5) (Fig. 6) (Fig. 7)
(Fig. 3) (Fig. 4)
AG3 Features
S T E P 1 Assemble Universal Cross Bar Stand
Set cross bars in a cross position and attach bottom pole stem (Fig. 1) to cross bar
stand with (4) supplied bolts and (4) washers (Fig. 2). Adjust universal cross bar
stand to accomdate your 16”, 18” or 20” square stones or concrete weights with (4)
supplied bolts and (4) washers. Secure stand with (4) square stones or concrete
weights (weights not included).
IMPORTANT: Cross bar stand will not support umbrella without proper weights.
Using the stand without weights will damage your umbrella.
S T E P 2 Assemble AG3 Frame
Insert AG3 mid-pole into bottom pole stem (Fig. 3). Line up holes until spring-loaded push
buttons pop out to lock frame into position (Fig. 4).
S T E P 3 Assemble AG3 Handle
Insert the crank handle into the axis (Fig. 5). Lock handle by screwing on the hex bolt (Fig. 6).
Use the allen wrench (provided) to fasten (Fig. 7).