Treasure Garden AG28SQ - Manual (Page 4)

S T E P 1 Assemble AG28/AG28SQ Base
Select area to set base and place in desired location.
Remove base lid from base shell and set aside (Fig. 1). Insert the base stem into the base
shell (Fig. 2). Turn collar base stem in a clockwise motion to engage threading. Fill
base shell with dry playground sand (not included). When filling base, it is necessary to wet
down sand after partial installation. (Fig. 3) Fill base with remaining sand and repeat wet
down.
NOTE: Base weight will be 250 lbs. after sand is added. Remove the base stem
carefully and avoid allowing sand into the center of the base shell (Fig. 4). IMPORTANT: Do not
allow sand to spill into the center of the base (Fig. 4) as it will interfere with collar base stem
installation. Place base lid back onto base shell.
8 3
CAUTION: Fully assembled, the AG28/AG28 umbrella weighs over 300 lbs. Moving
the umbrella fully assembled will increase the risk of damage to your umbrella and
can cause serious injury. We recommend a two-person team to assemble the
umbrella.
(Fig. 1)
(Fig. 3)
Avoid allowing sand
into the center of the
base shell.
!
(Fig. 2)
(Fig. 4)
To ATTACH VEGA Umbrella Light:
Loosen the VEGA light adapter built into the umbrella runner by turning counter-clockwise
(Fig. 20). After loosening, pull down light adapter post (Fig. 21) to attach the
VEGA umbrella light (sold separately).
To OPEN and ATTACH VEGA:
Open the VEGA umbrella light by holding firmly with one hand and then depress the clamp
release button with the other hand to release the clamp lock. Open up the VEGA light and
clasp around the light adapter post (Fig. 22). Snap to close (Fig. 23).
To REMOVE VEGA and CLOSE adapter:
Hold the VEGA umbrella light, depress the clamp release button to release the clamp lock.
Remove VEGA umbrella light, and gently push up the light adapter post back into umbrella
runner and tighten turning clockwise (Fig. 20).
(Fig. 20) (Fig. 21)
(Fig. 22) (Fig. 23)
AG28/AG28SQ Features