Treasure Garden AG28SQ - Manual (Page 6)

S T E P 3 Assemble AG28/AG28SQ Frame
To prevent scratching frame during assembly, lay umbrella parts on soft surface.
Attach the bottom pole into the housing, bottom pole only fits one way. Line up holes and
secure the two bolts with hexagon wren ch (Fig. 9). Insert crank handle into socket A of
housing (Fig. 10). Crank inner frame arm counter-clockwise until arm stops. To prepare
base for umbrella, release collar base stem by turning the collar counter-clockwise
(Fig. 11). Install umbrella frame into collar base stem.
(Two Persons Required) Secure
position by tightening the collar in a clockwise direction (Fig. 12).
NOTE: Cantilever will open counter-clockwise but not designed to be operated in that
matter.
6 5
(Fig. 10) (Fig. 9)
(Fig. 11)
(Fig. 12)
(Fig.13) (Fig.14)
(Fig.15)
Socket A Socket A Socket B Socket B Socket B
Socket A Socket A
To Adjust Vertical Shade:
Insert crank handle into socket A
(Fig. 15) and slowly crank counter-
clockwise to desired degree of
vertical shade.
S T E P 4 Opening and Closing
To Open and Extend Arm:
Insert crank handle fully into socket A (Fig. 13), crank handle will snap into place, then
slowly crank the handle clockwise until crank handle stops and arm is fully
extended.
CAUTION: Arm must be fully extended before retracting. Do not over crank, as it
will damage your umbrella.
To Open Canopy:
Insert crank handle fully into socket B (Fig. 14), crank handle will snap into place, then
slowly crank the handle clockwise until canopy is completely open and hub is
inserted under center pole and crank handle stops.
To Close Canopy:
Set canopy to horizontal position and turn crank handle socket B counter-clockwise.