Turning Technologies Mobi - Manual (Page 15)

MobiView 15
Changing the Digital Pen Battery
The digital pen uses a special rechargeable AAAA battery that typically lasts over a year with normal use.
The digital pen will go into sleep mode after two minutes of inactivity to conserve power. Store the digital pen in the MobiView’s
recharging pen holder when not in use.
NOTE
If the digital pen will not be used for an extended period of time (e.g., summer vacation), remove the
battery.
1 Depress the small tab and slide the two sections of the digital pen apart.
2 Insert the new battery with the positive (+) terminal facing towards the tip of the digital pen.
3 Depress the pen tip. The pen LED will flash four times if the battery was correctly inserted.
4 Align the ridges within the rear to the slots in the front section.
5 Slide the two sections together until the tab re-engages.
6 Charge the digital pen for 8 to 12 hours.
IMPORTANT
It typically takes three charge and discharge cycles for the rechargeable batteries to gain their full power
storage capacity. This is especially important for initial use, or anytime the digital pen battery is replaced.
turningtechnologies.com/user-guides