Testing the response devices – Turning Technologies TurningPoint AnyWhere User Manual
Page 18
TurningPoint AnyWhere User Guide
18
Testing the Response Devices
6
Press a button on the PresenterCard other than the Channel button.
The Detected Device ID appears in the window.
7
Click Pair.
8
Optionally, the programmable buttons can be customized by selecting the desired function from the
drop-down menus provided for each button.
9
Click Done to close the Settings Window.
Testing the Response Devices
Follow the steps below to assure that the receiver, ResponseCards, or ResponseWare is functioning properly.
How to test the response devices...
1
Click TurningPoint AnyWhere in the menu bar and select Preferences.
The TurningPoint AnyWhere Preferences window opens, displaying two tabs: Settings and Polling Test.
2
Select the Polling Test tab.
3
Click Start Test.
4
Press a button on a ResponseCard or send a response from ResponseWare.
5
The Device ID and response will appear if the connections have been properly configured.
6
Click End Test to complete the polling test.
7
Close the Preferences window when finished.
Note
Changing the channel on the device receiver, the
PresenterCard will need to be paired again.
Note
If the Device ID and response do not appear, verify
that the receiver and ResponseCard are on the
same channel. If using ResponseWare, verify the
internet connection.