Turning Technologies TurningPoint AnyWhere - Manual (Page 16)

TurningPoint AnyWhere User Guide 16
Configuring IR or RF Receivers
Configuring IR or RF Receivers
Prior to polling, it is recommended to verify the channel of the receiver. For the receiver to communicate
with the ResponseCards, both the receiver and ResponseCards must be on the same frequency (channel).
How to configure IR or RF receivers...
1 Plug in the IR or RF Receiver.
2 Click the Main Menu button on the showbar.
3 Mouse over Tools and select Settings.
4 Select Response Devices from the left panel.
For RF receivers, the device's ID will be listed below ResponseCard Channels. To change the frequency
(channel), select the receiver's channel number from the drop-down menu to the right. For IR receivers,
verify that the receiver serial number is listed below the IR.
5 Click Done.
Next Steps
Use the polling test to verify the devices have been configured properly. See Testing the Response Devices
on page 18 for more information.
Configuring ResponseWare
An active ResponseWare account is needed to complete the steps below. ResponseWare accounts can be
obtained by contacting a Turning Technologies representative. Please see Contact Us for contact
information.
How to configure ResponseWare...
1 Click the Main Menu button on the showbar.
2 Mouse over Tools and select ResponseWare.
3 Enter the Server Address. Default is www.rwpoll.com.
4 Enter Username and Password.