Two Notes Live - Manual (Page 23)

Configuring and using the TORPEDO Live
On a parameter page (change the page with the PARAMETER en-
coder), you will see on the first line the module name, the parame-
ter index and the number of parameters of the module.
On the second line you will find the parameter name and its value. Change the value using the VALUE
encoder. The following tab contains the modules list, their parameters with the possible values. All details about
the parameters are below.
Module Parameter Value
Power Amp On or Off
Model 8 models, from SE 6L6 to PP KT88
Volume 0 to 30dB
Presence If Model PP: 0 to 100%
Depth 0 to 100%
Type Triode or Pentode
Miking On or Off
Bank
Cab/mic, User 0 to User 3 (in User bank, the options Mic, Dis-
tance, Center and Position are not available). 32 memory
slots for Cab/mic, 128 per User bank
Cab or File Cabinet name or IR file name
Mic Microphone name
Distance 0 to 100% (i.e. 0 to 10 feet)
Center
0 to 100% (i.e. 0 to cabinet side, length depending on the
real cabinet geometry)
Position Back or Front
EQ On or Off
Mode Guitar or Bass
120Hz (Guitar) or 50Hz (Bass) -20dB to +20dB
360Hz/120Hz -20dB to +20dB
800Hz/360Hz -20dB to +20dB
2KHz/800Hz -20dB to +20dB
6KHz/4KHz -20dB to +20dB
Level -95 to 0dB
5.1 Power Amp
When using the TORPEDO Live with any kind of guitar/bass preamplifier, or even an electric piano or a synthesizer,
you need the color brought by the final stage of a traditional amplifier: the power amplifier. Plug your device
to the LINE input of the TORPEDO Live and enjoy the typical sound of the Two Notes electrically accurate virtual
tube power amplifier:
• Power Amp On: Activate the power amplifier simulation by turning "On" this parameter.
• Model: Choose the amplifier topology (Push Pull or Single Ended) and the tubes type (6L6, EL34, EL84 or
KT88).
• Volume: Set up the output volume of your virtual power amplifier.
Two Notes Audio Engineering TORPEDO Live 23