Ubiquiti Networks airFibe5 - Manual (Page 40)

37
Chapter 9: System Tab airFiber ® AF5/AF5U User Guide
Ubiquiti Networks, Inc.
Miscellaneous
Reset Button To allow use of the airFiber AF-5’s physical
reset button, check the box. To prevent an accidental reset
to default settings, uncheck the box.
Note: You can reset the airFiber AF-5 to default
settings via the airFiber Configuration Interface. Go
to the System tab > Reset to Defaults.
Location
After the on-board GPS determines the location of the
airFiber AF-5, its latitude and longitude are displayed.
If the GPS does not have a fix on its location, then
“Searching for Satellites” will be displayed.
Latitude The latitude of the airFiber AF-5’s location is
displayed.
Longitude The longitude of the airFiber AF-5’s location is
displayed.
Device Maintenance
The controls in this section manage the airFiber AF-5
maintenance routines: reboot and support information
reports.
Reboot Device Initiates a full reboot cycle of the airFiber
AF-5. Reboot is the same as the hardware reboot, which is
similar to the power-off and power-on cycle. The system
configuration stays the same after the reboot cycle
completes. Any changes that have not been applied are
lost.
Support Info This generates a support information
file that the Ubiquiti support engineers can use when
providing customer support. This file only needs to be
generated at their request.
Configuration Management
The controls in this section manage the airFiber AF-5
configuration routines and the option to reset the airFiber
AF-5 to factory default settings.
The airFiber AF-5 configuration is stored in a plain text file
(.cfg file). You can back up, restore, or update the system
configuration file:
Back Up Configuration Click Download to download the
current system configuration file.
Upload Configuration Click Choose File to locate the
new configuration file. Select the file and click Open.
We recommend that you back up your current system
configuration before uploading the new configuration.
Upload Click this button to upload the new configuration
file to the airFiber AF-5. Click Apply to confirm.
After the airFiber AF-5 reboots, the settings of the new
configuration are displayed in the Wireless, Network,
Advanced, Services, and System tabs of the airFiber
Configuration Interface.
Reset to Factory Defaults Resets the airFiber AF-5 to the
factory default settings. This option will reboot the airFiber
AF-5, and all factory default settings will be restored.
We recommend that you back up your current system
configuration before resetting the airFiber AF-5 to its
defaults.