VAC Phi 300 - Manual (Page 5)

3
UNPACKING & ASSEMBLY
Your amplifier has been shipped with the side and front glass in place. The following steps show
how these are installed, in the event that you ever need to change them.
Remove the screws that secure the aluminum top frame to the chassis
pillars. Turn counterclockwise to remove.
Take care to prevent the tool from scratching the chassis.
Remove the top frame.
From each of the four columns remove the tape, which prevented the
nylon setscrews from coming loose during shipment.
Slide the side glass plates into the pillars’ channels.
The glass will not go all the way to the chassis top, but has a gap at the
bottom for air flow.
Take care not to scratch or break the glass.