VAC Phi 300 - Manual (Page 7)

5
Set the beveled glass top into the aluminum top frame, oriented so that the
two holes are on the left and right side.
To prepare a Phi for shipment, follow these steps in reverse order.
When loosening the metal and nylon setscrews, be careful not to back them all of the way out of
the holes! If a metal screw falls into the amplifier, contact VAC for service directions.
NOTE: Do not remove and connect input cables or speaker cables while is amplifier is running.
Doing so risks damage to your loudspeakers or the amplifier.
Do not operate the amplifier without a loudspeaker or load resistor attached.