VAC Statement 450 Monoblock User Manual
Page 9
8
The top tube cage bars have a spring pin in each end.
To install, place one of the spring pins into one of the small dimples
machined into one of the side rails.
In the Illustration, the pin has been located into the left side rail.
To complete the installation, press the bar in the direction of the pin already
inserted, and manoeuver the other end into the corresponding dimple in
the other side rail, then release.
In this illustration, the bar is pressed to the left, while the right spring pin is
set into the dimple in the right side rail.
The amount of protrusion of each pin may be adjusted slightly if needed.
REMINDER:
Do not remove and connect input cables or speaker cables while is amplifier is
running. Doing so risks damage to your loudspeakers or the amplifier.
REMINDER:
Do not operate the amplifier without a loudspeaker or load resistor attached.
REMINDER:
Provide adequate ventilation may not be safe. Failure to do so may shorten the
amplifier’s life, and may result in tube failures. Operating the amplifier on a thick carpet
will also cause this, and is not safe.