Voodoo Lab Ground Control Pro - Manual (Page 17)

12
NORMAL. The CC message is only sent when you press the instant access button. You press
it once to turn it on, then again to turn it off.
XMIT W/PRSET. This stands for “Transmit with Preset”. When you call up a preset on the
Ground Control Pro, it will send out the current state (on or off) of this instant access
button. Of course it turns on and off when you press the button too.
MOMENTARY. This option means that it sends an “on” message when the instant access
button is pressed, then sends an “off ” message when it is released.
UTILITY
Utility allows you to change the speed of the scrolling preset directory, select the number of
presets per bank, and reinitialize memory to restore the factory defaults.
Directory Speed
This lets you control how fast the directory of presets scrolls when you enter a new Bank. To
change the directory speed, enter Setup mode by pressing both [SETUP MODE] buttons at the
same time, then press [UTILITY].
The display will read:
Press [-/NO] or [+/YES] to change the value from 1 (slowest) to 4 (fastest).
Presets / Bank
You can choose between having 10 or 4 presets in each bank.
10 Presets / Bank. With this selection you will use buttons 1-9 and 0 to select your presets.
Buttons [-/NO] and [+/YES] are used as increment and decrement so you can step through the
presets sequentially. This is a great feature if you have a rigid set list and want to pre-program
all of the changes. You will use [BANK
1 or 2] to select from 20 available banks, 0-9 then
A-J.
4 Presets / Bank. This way you will access your presets as banks of 4 presets each. You still
use [BANK
1 or 2] to choose the bank, but only buttons 1-4 on the bottom row (the large
white numbers on a gray background) to call up the presets. This frees the upper two rows for
instant access since you are only using the bottom row to recall your presets. If you want to
use the instant access buttons, you must choose 4 presets/bank.
The Ground Control Pro is initially set to 10 presets/bank. To change the selection, enter Setup
mode by pressing both [SETUP MODE] buttons at the same time, then press [UTILITY].
Press [SELECT
2] so the display reads:
Press [+/YES] to toggle between 10 and 4 presets/bank.
10 PRST/BANK
DIR SPEED=2