Voodoo Lab Ground Control Pro - Manual (Page 22)

17
Press [+/YES] to save your changes, or press [-/NO] to exit Edit mode without saving.
Note: If you exit Edit mode without saving, your changes will still be there until you select
a new preset. So if you change your mind, just go back into Edit mode and save it.
ASSIGNING MIDI PROGRAM CHANGES
After selecting a preset, enter Edit mode by holding down [EDIT] until the edit LED comes on.
You will see the name of the first device that you entered in Setup mode. If you haven’t changed
the device in Setup mode, then you have only one MIDI device named “DEVICE” which
responds to MIDI channel #1. The Ground Control Pro display will look something like this:
Now enter the number of the program you want for this device. You can access any program
from 0 to 128.
For example:
1. For program 6, press [0] [6]
2. For program 36, press [3] [6]
3. For program 112, press [1] [1] [2]
Notice that there is a slight delay when you select programs 10, 11, or 12. This is because the
Ground Control is waiting for a third digit in case you wanted programs 100 through 128.
You can also press [-/NO] and [+/YES] to step through your device’s programs one at a time.
If you have additional MIDI devices, press [SELECT
2] to go to the next one and enter its
program.
Note: The Ground Control automatically filters redundant program changes when presets
are recalled to avoid audible glitches. So if you change from one preset to another
that has the same MIDI program specified, it won’t send the program change
command again.
You can instruct the Ground Control Pro to not send a MIDI Program Change with this preset.
How you do this depends on whether your device numbers its programs from 0 to 127, or
from 1 to 128 (see “Start Number” on page 7). To not send a MIDI Program Change, do one
of the following:
• If the device starts at 1, then choose program 0 by pressing [0] [0].
• If the device starts at 0, then choose program 128 by pressing [1] [2] [8].
When no program is selected, the display will show “--” instead of a program number.
Program Number Device
ECLIPSE - 18
SAVE Y/N