Waldorf Nave - Manual (Page 18)

The Controls
Nave User Manual 18
The Edit Button
Tap on edit to open the Edit section of the wavetable
display. The following options and functions are availab-
le:
The Ribbon Band
The Ribbon Band easily enables you to play and hear the
current wavetable.
• Move your finger from left to right on the center
section of the Ribbon band to go forward through
the wavetable. Moving your finger from right to left
plays the wavetable backwards.
•
Tap on any location of the center section of the
Ribbon band to play the corresponding single
wave.
w
The last selected wavetable position on the Rib-
bon band will be automatically assigned to the
Wave
parameter when the editor is closed.
• Tap on the right section of the Ribbon band to start
the Travel function. The more right you tap, the mo-
re faster the wavtable will be go through forward.
• Tap on the left section of the Ribbon band to start
the Travel function. The more left you tap, the more
faster the wavetable will be go through backwards.
• By using the Dry / Wet switch you can hear the
wavetable without any other oscillator, filter, drive
and effects (Dry).
• The Octave Down/ Up button sets the playback
signal of the Ribbon band one octave up or down
with any tap.
3D Editing with the Selection Sliders
In the Edit section you can use three sliders to edit the
spectrum of the current wavetable in a 3D space. This
gives you unlimited sound changing possibilities.
• Use the Frequency slider to select a frequency
area. Tap on front or the back section of the slider
to limit the frequency area. Tap on the middle sec-
tion of the slider to move the selected frequency
area at once.