Weston Realtre Harvest Guar Sport Sealer - Manual (Page 6)

CLEANING INSTRUCTIONS
WARNING! Before cleaning, assembling or disassembling the Vacuum
Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
.
NEVER IMMERSE the Vacuum Sealer in water or other liquid.
.
Make sure the Vacuum Sealer has completely cooled before cleaning it.
.
Wipe clean all outside surfaces including the Plastic Vacuum Chamber and
Vacuum Lid with a damp cloth or paper towel. Most household spray cleaners are
safe to use. Avoid spraying cleaner or water directly into the vent on the left side of
the unit. DO NOT use abrasive cleansers!
.
Be careful while cleaning not to peel or damage the strip of Seal Bar Tape
covering the Seal Bar Heating Element.
.
Dry all surfaces and close the Vacuum Lid before storing the Vacuum Sealer.
THERMAL OVERLOAD PROTECTOR
The Vacuum Sealer will automatically shut down if it overheats. If this occurs, turn
the unit off and open the Vacuum Lid. Resume normal operation after the unit cools
or about 20 minutes.
To help prevent overheating, wait at least 20 seconds between cycles with the
Vacuum Lid open. Avoid touching the Seal Bar Tape. The Seal Bar Tape will remain
hot for a brief period of time after each sealing cycle.
This appliance has a Polarized Plug (one blade of the plug is wider
than the other blade). To reduce the risk of electrical shock, this
plug must fit fully into the outlet. If the blades do not fit into the outlet,
try turning the plug around. If the plug still does not fit into the outlet,
contact a qualified electrician. DO NOT attempt to modify the plug
in any way.
OUTLET INSTRUCTIONS
-6- -15-
1. Remove the Power Cord from the power supply.
2. Pivot the Compartment Lever over to open the Power Cord Storage Compartment
(Figure 7 ).
3. Loop the Power Cord up to about 3 1/2” (8.9 cm) long segments.
4. Place the Plug end of the Power Cord in the Power Cord Storage Compartment first.
Insert the looped portion of the Power Cord into the Compartment next.
5. Pivot the Compartment Lever over the Compartment to keep the Power Cord in
place.
6. If storing, return the Vacuum
Sealer to the original box for safe
keeping.
7. Store the Vacuum Sealer in
a cool, dry location.
STORAGE
Power Cord
Storage
Compartment
BOTTOM VIEW
Compartment
Lever
Figure 7