Wharfedale Pro PMX 710 - Manual (Page 16)

OPERATING MANUAL AND USER GUIDE
4
The Wharfedale Pro PMX System provides you with everything you need to get up and running for
a public performance.
• 1x PMX powered mixer
• 2x PT-X 2-way loudspeakers
• 1x DM 1.0 dynamic microphone
• 1x 4.5m microphone cable
• 2x speaker cables
A PMX System package comprises of a PMX powered mixer (PMX500 or PMX700), a pair of 2-way
loudspeakers (PTX-8 with the PMX 500 System and PTX-12 with the PMX700 System), a DM1.0
dynamic microphone and the necessary cables to connect the system.
Setting up a PMX System has been designed to be simple even for absolute beginners. Connect
the components as shown in the wiring diagram to create a basic vocal PA. Adding more equipment
is simple, always consult the user manual of any 3rd party equipment to ensure you will get the best
performance.
PMX SYSTEM OVERVIEW
In order to get up and running with your PMX System follow the steps below:
. Zero the mixer. This involves setting all level and send controls to minimum and all EQ controls
to 0dB.
2. Make all connections for audio and power as per the wiring diagrams:
. Ensure that the power switch is on the off position before connecting the AC supply.
2. Connect the microphone using the supplied XLR cable
3. Connect each speaker to the main outputs using the supplied speaker cables
3. If your microphones require phantom power use the rear panel switch to activate +48V supply.
4. Turn the power switch on.
5. Raise the level control for each of your connected sources, ensure that the Peak LED does not
constantly illuminate.
6. Raise the Mix Level control until you achieve the desired Sound Pressure Level (SPL).
NOTE
If the sound becomes distorted at higher volumes you may need to add extra equipment to achieve
the desired SPL, otherwise you may cause permanent damage to your system by overloading it.
QUICK START GUIDE