Wyred 4 Sound Mini MC Series User Manual
Page 4
_____________________________________________________________________
WYRED 4 SOUND MINI MC-SERIES v4.1
4235 Traffic Way
Atascadero, CA 93422
PH: 805-466-9973
FAX: 805-462-8962
©2013 WYRED 4 SOUND
All rights reserved.
Page 4 of 12
D
D
e
e
s
s
i
i
g
g
n
n
f
f
e
e
a
a
t
t
u
u
r
r
e
e
s
s
The Mini MC Series amplifiers are a multi-mono amplifier design that will produce peaks in excess of
250W with 8 ohm loads and 550W with 4 ohm loads per channel. Each of the mono amplifiers are powered
from their own dedicated power supply. The compact and effective design is made easy thanks to the switching
power supply that powers the bridged switching output stage derived from ICEpower™ technology.
In comparison with other products similarly provided by many companies, our product is superior. The MINI
MC Series amplifiers contain a fully balanced input stage which we designed to act as a buffer between your
amplifier and your input source. Our fully balanced input stage couples your gear directly to produce an input
impedance of 60.4K ohms which makes the integration of preamplifier selection endless. Other companies
connect the input and output connectors directly to the amplifier module which will not properly mate with select
preamp sources because of the low and unbalanced input impedance which will cause less than optimal sound.
Because of the compact size, the MINI MC amplifiers do normally run a bit warmer than our other amplifiers
despite the higher efficiency.
F
F
r
r
o
o
n
n
t
t
p
p
a
a
n
n
e
e
l
l
o
o
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
As you can see, the front panel doesn’t offer any sort of power switch or function buttons. The window
that is located in the middle of the front panel will appear to be blue when it’s is in operation mode. There is also
a potentiometer that can be accessed from the bottom of the unit to control the brightness of the light bar. A
small screwdriver like what is used on sunglasses must be used to adjust the brightness. Slowly adjust the turn-pot
until the desired brightness is achieved.
P
P
o
o
w
w
e
e
r
r
i
i
n
n
g
g
y
y
o
o
u
u
r
r
a
a
m
m
p
p
l
l
i
i
f
f
i
i
e
e
r
r
When power is applied to the amplifier and the switch located on the rear is in the on position, the
amplifier will turn on. If you would like to manually turn the amplifier on and off, this switch is where you would
want to do so. Leaving your amplifier on all the time will not hurt it, shorten the lifespan, or degrade the future
sound. The MMC series amplifiers make absolutely zero noise internally and to connected gear and shouldn’t be
in any way noticeable of its operation other than the blue light bar on the front panel. To prevent power surges,
we recommend using quality surge suppressor equipment. Turning the switch off on the rear of the unit will also
protect against surges and spikes should some occur without proper protection.
D
D
c
c
t
t
r
r
i
i
g
g
g
g
e
e
r
r
The Mini MC Series amplifiers are equipped with a 12Vdc remote trigger input and output. We highly
recommend using the DC trigger for powering the unit on and off. This will offer the least amount of turn on/off
noise. You can connect the 12V trigger output of your preamp or source to the 12V trigger input on the amplifier