Wyred 4 Sound Mini MC Series User Manual
Page 5
_____________________________________________________________________
WYRED 4 SOUND MINI MC-SERIES v4.1
4235 Traffic Way
Atascadero, CA 93422
PH: 805-466-9973
FAX: 805-462-8962
©2013 WYRED 4 SOUND
All rights reserved.
Page 5 of 12
for an easy remote power up every time. When the unit is in standby via the remote trigger, the amplifier is
powered up, but disabled. The current draw in standby mode is less than 5W per channel, and shouldn’t
measure on your electricity bill. The trigger input will work from 5-25V, so there shouldn’t be any issue with the
voltage tolerance on source equipments outputs rated for 12V.
L
L
i
i
g
g
h
h
t
t
b
b
a
a
r
r
b
b
r
r
i
i
g
g
h
h
t
t
n
n
e
e
s
s
s
s
The light bar can be adjusted for brightness through a clearance hole on the bottom of the chassis. As a
factory standard, the amplifiers are configured for maximum brightness. One can dim the light bar by using a
miniature flat head screwdriver (sunglass repair driver), and rotating the potentiometer on the bottom of the
chassis. The light bar to be turned completely off if so desired by rotating the potentiometer in the opposite
direction as delivered. Also having multiple amplifiers may require the units to be adjusted for common
brightness between units.
G
G
e
e
t
t
t
t
i
i
n
n
g
g
c
c
o
o
n
n
n
n
e
e
c
c
t
t
e
e
d
d
CAUTION: Disconnect the power cord or put the power switch in the off position before making any
connections to your amplifier to minimize the risk of electric shock and possible loudspeaker damage. Power
your amplifier after all final connections have been made. NOTE: This is a balanced amplifier and you should
NEVER connect either output to a ground point! Doing so may cause damage to your amplifier and/or
connected gear.
The binding posts that you will find on the MINI MC series are made of nothing but the best. Each binding post
is made of highly ductile “OFC” copper alloy. Both clamping nuts are built out of one piece, and offers excellent
grip. All metallic surfaces offer a 24-carat gold-plating, and are non magnetic surfaces. The binding post will
accept 4mm banana plugs, spades of 6 and 8mm, and crimped cable ends up to 10 AWG. The easiest
connection is made with banana plugs, but be sure that you use the highest quality that you can find. Make sure
that the banana plugs fit snugly into the terminals. Some inexpensive banana plugs can cause a highly resistive
connection which can result in a noticeably higher distortion output to the connected speakers.
The RCA (unbalanced) jack is made with high quality gold plated copper, and should be properly connected with
interconnects of the same value. The Neutrik XLR (balanced) connectors are the finest balanced connector on
the market, and are the best possible option for connecting your amplifier to your preamplifier
.
Using the new W4S power and interconnect cables would be a great way to ensure your system is closer to what
we call “our reference”. We are now offering superior cables at an affordable rate that anyone can afford. For
more information, please visit the web-site, or send an email to