XAIRCRAFT OSD - Manual (Page 3)

2 ©2013 XAircraft All Rights Reserved
Appendix 1: OSD Diagram on Screen
1. Number of Satellite: The number of satellite that GPS has picked up. There are 10 satellites in the diagram.
2. Battery Voltage: The voltage of battery. The diagram shows that the battery voltage is 14.3V.
3. Horizontal Velocity: The present velocity is 0.1m/s in the diagram.
4. Flight Mode: It may show M-Manual Mode, A-Attitude Mode, S-Safe Mode, G- GPS Attitude Mode or
W-Waypoint Mode. The present status is GPS Mode in the diagram.
5. Throttle: It’s 50% throttle in the diagram.
6. Horizontal Line: When OSD works at the FPV style, horizontal line can be regarded as real horizon. When
OSD works at the gimbal style, horizontal line can be regarded as attitude angle of aircraft. The working
mode of OSD can be changed in SuperX configuration software.
7. Pitch: Aircraft is at the status of pitching down in the diagram.
8. Low Battery Alarm: When the real voltage is lower than configured voltage, OSD raises the alarm. You can
set the alarm voltage in SuperX configuration software.
9. Safe Mode: When screen flickers this message, SuperX works under safe mode.
10. Heading: This heading indicates heading angle related to the take-off point. It’s nose in when it shows 180
degree; and it’s tail in when it shows near 0 or 360 degree.
11. Horizontal Distance: The current horizontal distance between aircraft and take-off point (over 4 satellites
were found before taking off). The diagram shows 23m from take-off point.
12. Height: The current height from the take-off point. The diagram shows the aircraft is at height of 14m.
13. Vertical Velocity: A down arrow in the sketch shows that the aircraft is descending at a speed of 0.9m/s.
14. Video Channel: The OSD supports 2 channels of video input. It’s AV IN2 in the diagram. Video channel can
be set in SuperX configuration software.