Toro CCR 3650 GTS Snowthrower 38517 - Manual (Page 2)

• Keep the area of operation clear of all persons,
particularly small children.
• Exercise caution to avoid slipping or falling, especially
when operating the snow thrower in reverse.
Preparation
• Thoroughly inspect the area where the equipment is to
be used and remove all doormats, sleds, boards, wires,
and other foreign objects.
• Do not operate the equipment without wearing
adequate winter garments. Avoid loose fitting clothing
that can get caught in moving parts. Wear footwear that
will improve footing on slippery surfaces.
• Handle fuel with care; it is highly flammable.
– Use an approved fuel container.
– Never add fuel to a running engine or hot engine.
– Fill fuel tank outdoors with extreme care. Never fill
fuel tank indoors.
– Never fill containers inside a vehicle or on a truck
or trailer bed with a plastic liner. Always place
containers on the ground, away from your vehicle,
before filling.
– When practical, remove gas-powered equipment
from the truck or trailer and refuel it on the ground.
If this is not possible, then refuel such equipment
on a trailer with a portable container, rather than
from a gasoline dispenser nozzle.
– Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times, until refueling
is complete. Do not use a nozzle lock-open device.
– Replace gasoline cap securely and wipe up spilled
fuel.
– If fuel is spilled on clothing, change clothing
immediately.
• Use extension cords and receptacles as specified by the
manufacturer for all units with electric starting motors.
• Never attempt to make any adjustments while the engine
is running (except when specifically recommended by
manufacturer).
• Always wear safety glasses or eye shields during
operation or while performing an adjustment or repair
to protect eyes from foreign objects that may be thrown
from the machine.
Operation
• Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
• Exercise extreme caution when operating on or crossing
gravel drives, walks, or roads. Stay alert for hidden
hazards or traffic.
• After striking a foreign object, stop the engine, remove
the ignition key, thoroughly inspect the snow thrower
for any damage, and repair the damage before restarting
and operating the snow thrower.
• If the unit should start to vibrate abnormally, stop the
engine and check immediately for the cause. Vibration
is generally a warning of trouble.
• Stop the engine whenever you leave the operating
position, before unclogging the rotor blades or
discharge chute, and when making any repairs,
adjustments or inspections.
• When cleaning, repairing or inspecting the snow
thrower, stop the engine and make certain the rotor
blades and all moving parts have stopped. Disconnect
the spark plug wire and keep the wire away from the
plug to prevent someone from accidentally starting the
engine.
• Do not run the engine indoors, except when starting
the engine and for transporting the snow thrower in or
out of the building. Open the outside doors; exhaust
fumes are dangerous.
• Exercise extreme caution when operating on slopes.
• Never operate the snow thrower without proper guards,
and other safety protective devices in place and working.
• Never direct the discharge toward people or areas where
property damage can occur. Keep children and others
away.
• Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
• Never operate the machine at high transport speeds
on slippery surfaces. Look behind and use care when
operating in reverse.
• Disengage power to the rotor blades when snow
thrower is transported or not in use.
• Never operate the snow thrower without good visibility
or light. Always be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
• Never touch a hot engine or muffler.
2