DYSON DC 01 - Manual (Page 4)

1. Remove soleplate
Undo three cross-head screws.
Remove soleplate by lifting from the back, and then
remove brush bar.
If cradle becomes detached from soleplate, align
circular ends of cradle with corresponding holes of
soleplate and slot into place, ensuring that ‘front’
edge of cradle faces the right direction.
3. Centralise belt
2. Line up brush bar
Thread removal
After unplugging the cleaner, carefully remove any
entwined cotton, wool or fluff with scissors.
NOTE: Failure to remove these may result in loss of
performance and possible damage to the machine.
3. Changing the belt
Replacement belts are available direct from
Dyson Customer Care (Tel: 01666 827272)
Fit belt over motor
shaft and domed
section of brush bar.
Pull belt taut and
locate brush bar
in slot.
1
2 1
2
D Y S O N C U S T O M E R C A R E
T E T B U R Y H I L L
M A L M E S B U R Y
W I L T S H I R E
E N G L A N D
S N 1 6 O R P
1
1
1
2
2 With raised section
on end of brush bar
orientated as
shown, locate brush
bar in slot and
rotate end cap
towards back of
machine until it
comes to a stop.
End cap of brush bar
Raised section
3
Cradle
Soleplate
IMPORTANT Use only genuine Dyson belts.
Helpline 01666 827272
Facsimile 01666 827298
Contact for all service assistance
3
1
2
Rotate brush bar by
hand to centralise
belt before re-fitting
soleplate to machine.
VERY IMPORTANT
W A R N I N G ! For your own safety please
remember to unplug the machine when not
in use and before carrying out maintenance.