Ryobi SSP200 - Manual (Page 8)

8 — English
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:

Interior and exterior painting and staining of decks,
outdoor furniture, fences, and walls
WARNING:
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
FILLING SPRAYER WITH PAINT/STAIN
See Figures 4 - 5, page 12.
Remove and discard any skin that has formed on top of the
paint or stain, then thoroughly mix the material in its original
container before beginning.
NOTE: Older containers of stain and paint may need to be
strained before use.

Unplug the sprayer.
 Remove the quick-lock container by twisting counter-
clockwise so that the arrow on the container lines up with
the “unlock” symbol on the lid.
 Fill the container with paint or stain as desired. Do not fill
above the max fill mark on the container.
 Reinstall the container on the sprayer and twist clockwise
so that the arrow on the container lines up with the “lock”
symbol on the lid.
SELECTING THE PROPER SPRAY TIP
See Figure 6, page 13.
Use the 1 in. round fan tip for latex paints
and stains. This tip sprays in a round pattern.
Use the 12 in. wide fan tip for latex paints,
oil-based paints, and stains. This tip sprays
in a wide pattern that can be adjusted from
horizontal to vertical.
To switch tips:

Unplug the sprayer.
 Remove the installed tip by turning it counter-
clockwise.
 Install the desired tip and rotate clockwise to tighten
securely.
NOTE: The tip should be tightened securely by hand. A
too loose or overtightened tip may cause the sprayer to
leak or be damaged.
To change direction of wide fan tip:

Slightly loosen the wide fan tip by rotating counter-
clockwise 1/4 turn.
 Rotate the adjusting arm 1/4 turn in the direction needed
to switch the direction of the tip spray.
 While holding the adjusting arm in position, rotate the
wide fan tip clockwise until securely tightened.
WARNING:
To reduce the risk of injection, do not point sprayer at
any part of the body or person. In case of skin injection,
seek medical attention immediately. Do not use without
spray tip in place.
OPERATING THE SPRAYER
See Figures 7 - 10, page 13.

Place a line of lubricant on the piston. To gain access to
the piston, follow the instructions in Cleaning the Sprayer
for Storage in the Maintenance section of this manual.
 Ensure surface to be painted is free of dust, dirt, and
grease.
 Mask or cover any areas not intended to be painted or
stained. Be aware of wind that may cause your paint or
stain to spray into areas not desired. Always use drop
cloths or other cover to protect areas that are not intended
to be painted or stained.
 Fill the container with paint or stain as desired. Do not fill
above the max fill mark on the container.
NOTE: After every 4 refills of the quick-lock container,
add a line of lubricant to the piston. See
Cleaning the
Sprayer for Storage for instructions on disassembling
the sprayer to gain access to the piston.