Ryobi CFS1503 - Manual (Page 6)

6 - English
FEATURES
PRODUCT SPECIFICATIONS
Sanding Pad Length ..............................................5-1/2 in.
Orbit Diameter ........................................................ 1/16 in. No Load Speed ..............................................12,500 OPM
Input ................................. 120 V, 60 Hz, AC only, 1.2 Amp
ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
OPERATION
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
 Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below when
using the appropriate sanding sheet or pad:

Sanding on wood surfaces
 Removing rust from and sanding steel surfaces
 Polishing and scrubbing porcelain and metal
SANDING SHEET SELECTION
Selecting the correct size grit and type sanding sheet is an
important step in achieving a high quality finish. Aluminum
oxide, silicon carbide, and other synthetic abrasives are best
for power sanding. Natural abrasives, such as flint and garnet
are too soft for economical use in power sanding.
In general, coarse grit will remove the most material and finer
grit will produce the best finish in all sanding operations. The
condition of the surface to be sanded will determine which
grit will do the job. If the surface is rough, start with a coarse
grit and sand until the surface is uniform. Medium grit may
then be used to remove scratches left by the coarser grit and
finer grit used for finishing of the surface. Always continue
sanding with each grit until surface is uniform.
ATTACHING HOOK-AND-LOOP SANDING
SHEETS
See Figure 1, page 10.

Unplug the sander.
 Align holes in hook-and-loop type sanding sheet with
holes in pad, then carefully press fuzzy side of the sand-
ing sheet against pad as tightly as possible.
NOTE: Hook-and-loop type sanding sheets can be
reused for the life of the sanding abrasive. It is rec-
ommended that you keep the sanding sheet back-
ing clean to provide for best adhesion. Clean the
sheet and hook-and-loop pad by brushing lightly
with a light brush.