Ryobi RP4300 - Manual (Page 7)

7 — English
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
ASSEMBLY
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:

Chime mode can be used in applications that require an
entry announcement such as a doorway or hallway. It can
also be used as an audible caution when someone has
entered a dangerous or unauthorized area.
 Alarm mode helps deter intruders in a specified area.
TO INSTALL/REMOVE BATTERY PACK
See Figure 2, page 10.
NOTE: Whenever the battery is removed from the motion
alarm, the personal security code will be reset to the factory
default after 10 seconds.

Loosen the screw located on the bottom of the motion
alarm and allow the battery compartment door to swing
open.
 Place the battery into the battery compartment.
NOTE: The raised rib on the side of the battery must be
aligned with the groove in the battery compartment.
 Close the battery compartment door and tighten screw
to secure.
NOTE: Any time the red LED is on, the battery needs to
be recharged.
CAUTION:
Ensure the battery has enough charge to last throughout
the monitoring period desired.
INSTALLING/CHANGING THE REMOTE
BATTERIES
See Figure 3, page 10.
The remote control for the motion sensor uses two 3 Volt
button cell batteries (type CR 2032) that must be installed
before you can operate the remote.

Press down on the visor clip on the back of the remote
to remove the back cover.
NOTE: If the visor clip has been removed, press down
on the back cover of the remote.
 If changing batteries, remove the two depleted batteries
from under the holding clips and discard.
 Secure two new batteries under the holding clips.
NOTE: Make sure the ( + ) side of the battery is facing up
as shown.
 Replace the back cover and push up on the cover (not
the visor clip) to secure.
SETTING A PERSONAL SECURITY CODE
See Figure 4, page 10.
The motion alarm allows you to choose your own personal
security code which can range from 4 to 10 digits.
NOTE: The device must be in disarm mode to change the
security code.

Press and hold the # key while entering the default se-
curity code — 0000.
NOTE: If you have previously changed the default code,
enter the current security code instead of the default code
at this time.
 Release the # key. If the code was entered successfully,
the green LED will turn on.