Dometic RM 7361 L - Manual (Page 22)

22
Installation recess
The refrigerator must be installed draught-free in a recess (see point “6.2”).
The measurements of the recess are given in the table below.
Step (A) is only required for cabinets with a step. Push the appliance far enough into
the recess until the front edge of the refrigerator casing is flush with the front of the
recess. Allow a gap of 15-20 mm between the back wall of the recess and the
refrigeration unit. The floor of the recess must be level, allowing the appliance to be
pushed easily into its correct position. The floor must be substantial enough to bear the
weight of the appliance.
Ensure that the refrigerator is installed level in the recess.
Recess measurements:
Model Hight H Width W Depth T Heigh HSt Depth TS
Securing the refrigerator
In the sidewalls of the refrigerator, there are four plastic
sleeves with screws for securing the refrigerator. The
sidewalls or rails attached for securing the refrigerator
must be designed in such a way that the screws will
remain firmly in place even when under increased load
(while the vehicle is moving).
Always insert screws through the sleeves provided;
otherwise, structural parts embedded in the foam,
such as cables, etc., may be damaged.
Once the refrigerator is in its final position, secure the
screws into the wall of the recess.
The screws must penetrate through the sheet metal
casing of the refrigerator.
6.5
6.6
Width of recess = W Width of recess = W
RM 7271 825 mm 490 mm 515 mm 220 mm 235 mm
RM 7275 825 mm 490 mm 515 mm 220 mm 235 mm
RM 7291 825 mm 529 mm 515 mm 220 mm 235 mm
RM 7295 825 mm 529 mm 515 mm 220 mm 235 mm
RM 7361 825 mm 490 mm 515 mm - -
RM 7365 825 mm 490 mm 515 mm - -
RM 7371 825 mm 490 mm 580 mm 220 mm 235 mm
RM 7401 825 mm 529 mm 515 mm - -
RM 7405 825 mm 529 mm 515 mm - -