D-Link DE81 2TP+ - Manual (Page 11)

To connect the Ethernet Hub to a thick coaxial
cable (lOBase cable), it is necessary to have a
lOBase Ethernet transceiver (tap) on the cable at
the Ethernet Hub’s position. Then run an AUI
cable between the transceiver’s AUI connector and
the AUI connector on the rear panel of the Ethernet
Hub.
AUI port
-AU1 cable
x Transceiver
Connecting Power
For compatibility with electric service in most
areas of the world, the Ethernet Hub’s power
supply automatically adjusts to line power in the
range 100 - 240 VAC and 50 - 60 Hz.
Per ordering option, either a Type 1 (US) or Type 2
(European) power cord is supplied with your
Ethernet Hub. See Spefications, below, for power
cord details.
Ascertain that the power switch on the rear panel
of the Ethernet Hub is in the off position. Plug the
female end of the power cord firmly into the
9