Oldsmobile 1999 Aurora - Manual (Page 95)

yellow blue
2-37
Lamps On Reminder
If the headlamp switch is left on you’ll hear a warning
chime when you turn the ignition off, remove the key
from the ignition and open the driver’s door.
Flash-To-Pass
This feature lets you use your high - beam headlamps to
signal a driver in front of you that you want to pass. It
works even if your headlamps are off.
To use it, pull the turn signal lever toward you.
If your headlamps are off, your high - beam headlamps
will turn on. They’ll stay on as long as you hold the
lever there. Release the lever to turn them off.
If your headlamps are on, but on low beam, the system
works normally. Just pull the lever until it clicks. Your
headlamps will shift to high beam and stay there. To
return to low beam, just pull the lever toward you.
If your headlamps are on, and on high beam, your
headlamps will switch to low beam. To get back to high
beam, pull the lever toward you.
Windshield Wipers
The lever on the right side of your steering column
controls your windshield wipers.
For a single wiping cycle, move the lever up to MIST.
Hold it there until the wipers start, then let go. The
wipers will stop after one cycle. If you want more
cycles, hold the lever to MIST longer.
For steady wiping at low speed, push the lever down to
the LO position. For high
- speed wiping, push the lever
down further, to HI. To stop the wipers, move the lever
to OFF.