Optoma OWM1000 - Manual

Attach Wall Plate To Wall 1
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
read these instructions carefully before installing your equipment.
install the mount in a suitable location using fixings which are appropriate for the wall material and structure. Consult a
qualified builder if you are in any doubt as to the structural integrity of the wall.
use all available fixing points.
do not attempt to alter or modify any part of the wall mount or it's attachments.
do not use if any parts are broken or appear to be damaged.
tighten all bolts and fixings securely. Only use fixings provided with this bracket.
do not mount your projector near to sources of heat or moisture.
always have a minimum of two persons to install the projector and the mount.
1
Ÿ For ease of installation mount bracket on wall using position 1
and mark other positions using a spirit level. Then remove
fixing from position 1, remove bracket and drill other positions
Ÿ Use Fixings suitable for your type of wall construction.
Ÿ Use All available fixing points.
Ÿ If in any doubt of the suitability of the wall, it's construction or what
type of fixings to use, consult a qualified builder or installer.
NOTE:
Ÿ For mounting OPTOMA XGA and WXGA Ultra Short Throw
Projectors locate the wall plate centrally to the screen centre.
Remove wall plate trim before attaching to wall
NOTE: Retain fixings for re-attaching trim later.
MODEL No. OWM1000
FN.
Max Weight Loading 15Kgs
OWM1000
a
b
Projector Fixing Kit
Mount Assembly Kit
A - M3 x 10mm
B - M4 x 10mm
C - M5 x 10mm
D - M6 x 10mm
I - M3 Washer
J - M4 Washer
E - M3 x 25mm
F - M4 x 25mm
G - M5 x 25mm
H - M6 x 25mm
K - M5 Washer
L - M6 Washer
M - M5 x 15mm
N - M6 x 15mm
Also Required
O - Extension Arm
Cable protection grommet
P - M5 x 10mm
x4
x2
x4
x4
x4
x4
MOUNTING INSTRUCTIONS FOR
SHORT THROW PROJECTOR MOUNT
To fit Optoma:
X307UST / X307USTi / W307UST / W307USTi