Tascam CD-01U - Manual (Page 24)

External parallel control
Restoring factory default settings
7 - Advanced operations
The CD-01U Pro can be controlled from an external
devices which supports a parallel interface via the CON-
TROL I/O terminal on the rear panel.
Pin No. Description In/Out
1 Stop tally Out
2 Skip (Back) In
3 Skip (Forward) In
4 No Disc tally Out
5 EOM tally Out
6 Search (Back) In
7 Search (Forward) In
8 GND
9 Play tally Out
10 Pause tally Out
11 Fader start/stop In
12 Stop In
13 Play In
14 Pause In
15 +5V
In:
Input signals are active when low (ground) for > 30 ms.
Out:
Tally signals are open collector, with a maximum current of 50 mA.
+5V:
The maximum current supplied from this terminal is 50 mA.
24
TASCAM CD-01U/CD-01UPro
Event start
Connect the RELAY IN jack (mini jack) on the rear panel
and event start terminal on the external device which
supports the event start function.
The relay play menu (menu number 06 RELAY) should
be set to ON.
1 8
9 15
REMOTE(PARALLEL)
To restore all settings to their factory defaults:
1 Select the factory preset menu (menu number 14 F-
PRE).
2 The display shows 14 flashing, then press the PITCH
knob on the front panel or ENTER key on the remote
control to confirm the selection.
3 The display shows - SURE - flashing to recomfirm
that this operation is surely desired.
4 Press the PITCH knob on the front panel or ENTER
key on the remote control to restore all settings to
their default values.
The following settings are restored to default values.
≠ Playback mode
≠ Time display mode
≠ Auto ready
≠ Auto cue
≠ Pitch control value
≠ All menu settings
You can cancel to restore the default settings either the
stage 14 F-PRE or SURE is flashing by pressing the
other keys except the SHIFT key and the PITCH knob
on the front panel.