Tascam CD-01U - Manual (Page 26)

8 - Specifications
Dimensional drawing
Error messages
Err 01 TOC Read error - the disc's Table of Contents cannot be read - try with another disc or remove and clean the
existing disc before replacing it
Err 02 GFS error GFS signal cannot be detected - try with another disc or remove and clean the existing disc
before replacing it
Err 03 Focus error - after repeating the attempt eight times to focus, an error still occurs - try with another disc or
remove and clean the existing disc before replacing it
Err 04 Sub-Q error - the sub-Q code cannot be detected - try with another disc
Err 05 Loading error - the loading operation cannot be completed, even after retries, or there is an internal error - make sure
that there are no obstructions preventing the loading operation
Err 06 Sled error - an internal drive error - try turning the power off, waiting a few seconds, and turning it on again
Err 07 S-DRAM error - an internal S-DRAM error - try turning the power off, waiting a few seconds, and turning it on again
Err 08 System error - an internal error - try turning the power off, waiting a few seconds, and turning it on again
If any of the numbered error messages occur, try using another disc.
If the errors continue with a number of discs, turn the unit off, wait for a few seconds, and turn it on again.
If the errors still continue or other error occurs, contact your TASCAM distributor for repair.
310.8mm (12.2") 333.9mm (13.1")
44mm (1.7")
16.5mm (0.6")
6.6 mm (0.3")
482.6mm (19")
435mm (17.1")
50mm (2")
26
TASCAM CD-01U/CD-01UPro