Applied Motion SWM24IP-3EE - Manual

Requirements
▪ A 12-70V DC power supply.
▪ A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit).
▪ ST Confi gurator™ software (available at www.applied-motion.com/products/software).
▪ A 3004-277-5M power cable, 3004-290-5M I/O cable, or a 3004-280-5M Ethernet cable, as needed.
▪ NOTE: Cables are NOT included and must be purchased separately.
▪ For more detailed information, please download and read the SWM24 Hardware Manual, available at www.applied-motion.
com/support/manuals.
To begin, make sure you have the following equipment:
Step 2
a) Download and install the ST Confi gurator™ software.
b) If you intend to connect the drive directly to your PC, confi gure your computer to use IP address 10.10.10.11. (For
instructions on connecting your STM drive to a local area network (LAN), please consult the STM23 Hardware Manual)
c) Do not connect the Ethernet cable to the SWM24 before applying power. This will cause the drive to use its recovery
address, thus assigning itself IP address 10.10.10.10. (See the SWM24 Hardware Manual for further details on
selecting IP addresses for the drive and PC)
d) Launch the software by clicking: Start / All Programs / Applied Motion Products / ST Confi gurator
Step 1
Wire the drive to the DC power source.
(Do not apply power until Step 3)
Note - the SWM24 accepts DC voltages from 12-70V. If using an
external fuse, we recommend a 5 amp fast acting fuse.
(See the SWM24 Hardware Manual for more information about
power supply and fuse selection.)
Connect I/O, if required by your application. A 3004-290-5M
cable will be required.
(See the SWM24 Hardware Manual for more information about
wiring I/O to the SWM24.)
GND
EMI Filter
AC
Power
Input
L IN
E
L
O
A
D
L
N N
L
V+
V-
P/N:092.00823.00 (LCR)
4
3
1
2
POWER
DC POWER
SUPPLY
V-
V+ V+
V-
GND
920-0070 Rev B
SWM
SWM24 Ethernet Quick Setup
Guide