Applied Motion SWM24IP-3EE - Manual (Page 2)

Step 3
If you have any questions or comments, please call Applied Motion Products Customer Support:
(800) 525-1609, or visit us online at www.applied-motion.com.
404 Westridge Dr.
Watsonville, CA 95076
Tel: 800-525-1609
Fax: 831-761 -6544
www.applied-motion.com
a) Apply power to the drive. Wait approximately 5 seconds, then connect the Ethernet cable to the network.
In the absense of a valid network connection the drive will default to its recovery address, 10.10.10.10.
b) Select the “Ethernet” radio button in the center of the screen and specify the target
IP adress of 10.10.10.10. Click ‘Upload from drive’. If successful, you should see a
screen similar to that shown below, allowing the user to fully confi gure the drive.
c) To specify a new IP address for the drive, select “Drive” --> “Edit IP Address
Table” from the drop-down menus at the top of the screen.
d) Click the “Read from Drive” button to refresh the list, noting that only the
fi rst entry may be edited. Specify a new IP address in these fi elds.
e) Follow the confi guration instructions in the ST Confi gurator™ screens. The ST Confi gurator™
software can be used to set up your drive to operate in several different modes including: pulse
& direction, velocity (oscillator), streaming commands (SCL), and Q programming mode.
f) ST Confi gurator™ includes a self test option (under the Drive menu) to verify
that the SWM24 and power supply are correctly wired and confi gured.
g) Once confi gured, use the ‘Download to Drive’ button to permanently save the confi uration to the drive.
h) Note that if connected to the network when power is applied, the drive will use
the IP address specifi ed in the IP address table, position 1 (see step D above). If not
connected to a network, the drive will default to the recover address of 10.10.10.10. This
feature allows a user to connect to a drive even if its IP address is not known.
920-0070 Rev B
SWM24 Ethernet Quick Setup
Guide