Atlona AT UHD EX 100CE - Manual (Page 3)

3
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Introduction
Pass through support of 4K (UHD), 2560x2048 , IR, RS-232, bi-directional Ethernet, and lossy/lossless
audio signals up to 328ft (100m). The 100CE extenders provide an affordable, high quality, solution
for your audio and video needs.
Package Contents
Kit
RX
Features
• 1 x AT-UHD-EX-100CE-TX
• 1 x AT-UHD-EX-100CE-RX
• 1 x 48V DC power supply
• 5 x Female captive screw connector (2 pin (x1): power, 3 pin (x2): RS-232, and 5 pin (x2): IR)
• 2 x Pair of wall/table mount ears
• 2 x Pair of screws for wall/mount ears
• 1 x IR emitter (AT-IR-CS-TX)
• 1 x User manual
• 1 x AT-UHD-EX-100CE-RX
• 2 x Female captive screw connector (3 pin: RS-232 and 5 pin: IR)
• 1 x Pair of wall/table mount ears
• 1 x Pair of screws for wall/mount ears
• 1 x IR emitter (AT-IR-CS-TX)
• 1 x User manual
• Extends IR, RS-232, Ethernet, and audio/visual content up to 328ft over a single category cable
• Supports resolutions up to 4K (UHD) 60Hz @ chroma sub-sampling 4:2:0 8-bit
• IR ports for use with IR remote controls and 3rd party IR controllers
• Bi-directional Ethernet pass through
• Provides PoE (Power over Ethernet)
• Multichannel audio pass through up to Dolby TrueHD, DTS-HD Master Audio, and Dolby Atmos
• Full 3D pass through
• HDCP 2.2 compliant
• Field updatable firmware
Before You Start
• When installing the extenders DO NOT:
Cover the vents
Install into a sealed wall
Install into an area without adequate air ventilation
Do not
cover
venting!
Connect the screws to these
four holes when mounting to
a wall.
*Remove the side screws from the case and use for bracket installation
Connect the screws to these
four holes when mounting to a
table.