Atlona AT LINE PRO5 - Manual (Page 3)

www.atlona.com | toll free: 1-877-536-3976
For International: 1- 408-962-0515
3
INTRODUCTION
PACKAGE CONTENTS
APPLICATIONS
The Atlona AT-LINE-PRO5 is a professional quality 11-input video scaler/processor/presentation switcher that
allows 4 x HDMI or DVI, 1 x DVI, 3 x VGA, 2 x Component, 2 x Composite video inputs to be scaled to a dual
HDMI Output (outputs are mirrored). The on-screen display gives you the ability to change video options, scal-
ing options, output resolutions and much more. With additional functions as RS232 and IR the AT-LINE-PRO5 is
easier than ever to control or integrate with preexisting system.
• AT-LINE-PRO5 – 11 input video scaler/presentation switcher
• 5V/3A DC power supply (110/240V)
• IR Remote Control
• Rack Ears
• Instructions manual
• Conference Room/Board Room - Display any in-source on a conference room TV or and Projector at the
same time.
• School/University – perfect for any digital interactive classroom. Ability to plug-in up to 11 sources which will
be scaled to the native resolution of the display.
• Places of Worship – display any source material on the project and get the same resolution at all the time.
FEATURES
• Scaling any incoming Signal whether HDMI, DVI, VGA, Component or Composite to the native resolution of the
display: VGA~WUXGA or 480p~1080p
• Audio embedding from any input to HDMI outputs
• De-embedding audio from HDMI outputs to coaxial output to allow video be routed to a projector and audio
to an amplifier.
• PAL to NTSC and NTSC to PAL conversion 50/60Hz
• RS232 commands available for control systems
• IR Commands are available for using a universal remote or an IR control system
• Standard 1U size for easy rack mounting
• Each input is accompanied with stereo audio input, including HDMI so that it could be used with DVI sources
• Full 3D support on HDMI pass through
• Horizontal and vertical shift, color, tint, brightness, contrast, detail, sizing, and top and bottom vertical blanking
adjustments
• HDMI 1.3, HDCP 1.2 and DVI 1.0 compliant
• Supports input PC timing: VGA ~WUXGA (Reduced Blanking Rate), 480p~1080p
• Support input HDMI timing: 480i~1080p60 and VGA~WUXGA (Reduced Blanking Rate)
• 1080p@60Hz color video up to 12 bits, 1080p@60Hz
• Supports audio PCM 2CH
• Supports deep color of 8 / 10 / 12 bits
• Supports OSD
• Auto-detection and auto-tune
• 3-D motion adaptive & 3-D video noise reduction
• Video-over-graphic overlay
• ADC for both video and audio
• Image of color bar: If user is seeing a color bar, it means that there is no input signal present. The color bar will
be active for 15min and after the Atlona device will go to the stand-by mode and disconnect from the display.
As soon as incoming video signal will resume, the Atlona device will establish a new connection with the
display.