Atlona AT HSDI VGA - Manual (Page 4)

Toll free: 1-877-536-3976
Local: 1-408-962-0515 4 atlona.com
Panel Description
Front Panel
1. Power indicator, the LED will glow blue when the AT-HSDI-VGA is plugged into the power outlet.
2. SDI signal detection will light up the green LED that corresponds with the signal quality that is being
received.
3. Menu button, used to enter or leave the on screen display menu.
4. Enter button, use it to confirm selection or press together with the - button to default to 720p
(component video) or with the + button to default to 1024x768 (VGA)
5. Plus and minus buttons are used to move through the OSD selection or used with the enter button
to set to a default output resolution.
1. Input port. Connect your SDI device to this port to be routed to PC/HD or Looped out to an SDI
device.
2. Loop out port. Use this port to send your SDI signal to an SDI device, with the built in equalizers you
can extend the distance your SDI input can go or stream the signal to an SDI and a PC/HD device
simultaneously
3. Audio output ports. Connect to an amp using either digital or analog signals.
4. YUV/RGBHV output port. Connect to your PC or HD display. Use a D-Sub 15pin cable for PC
connection and a HD15 to component breakout cable (i.e. AT19072).
5. Power connector. Plug in your DC 5V power supply into this port.
1
1 2 3 4 5
2 3 4 5