Atlona AT HDDVI1616 AM - Manual (Page 11)

Toll free: 1-877-536-3976
Local: 1-408-962-0515 11 atlona.com
Output 2
1920x1280
Input 4
1920x1200
Input 2
1280x720
Input 8
1280x720
Output 5
Output 11
1920x1200
1920x1200
Learning
Learning EDID allows for the resolution and audio formats of a display to be saved to an input
source. Once this setting is saved it will only output that resolution and audio, which will
cause a black screen to display on any output that does not support the same settings.
In the above diagram, output5 can be saved to all 3 inputs allowing all three outputs to use
the devices at 1280x720 (most displays have multiple resolution capabilities. Outputs 2 & 11
however can only be saved to inputs 2 & 4 as their native resolutions are 1920x1200 and
input 8 is incapable of producing that resolution without a scaler.
The AT-HDDVI1616-AM uses captive screw connectors for audio. Captive screw uses two
types of audio: balanced and unbalanced. To be sure which to use refer to the manual for the
connected device.
There are 3 connection possibilities, 2 unbalanced and 1 balanced (see picture below). When
used, a balanced input can only output balanced audio and an unbalanced input can only
output unbalanced audio but either unbalanced connection can be used.
Default
Default is used for when all displays support 1920x1200. If a display does not support this
resolution then it will show only a black screen. (i.e. Output5 having the native resolution of
1280x720 would cause it to show only a black screen in default)
Audio
(Balanced and Unbalanced)