Atlona AT H2H 44M - Manual (Page 12)

12
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
---> ---> --->
---> ---> --->
AT-H2H-44M
Select Input Number
Select output number
(1-4) to set ARC mode
Output: # Current: On
Select mode 1: On 2: Off Output: # Current: On
Select mode 1: On 2: Off
Output: # Current: Off
Select mode 1: On 2: Off
Select Function Option
home screen
Hold for
5 seconds
through
--->
--->
-----------------------
ARC enables a source connected to a display to route audio to an AVR or zone amp.
The S/PDIF port is used for two audio options, ARC or matrix source audio loop-out. When using
one, the other is disabled. By default the matrix comes with ARC turned off on all ports, this
enables the S/PDIF to loop-out the audio from the matrix source. To switch between ARC and
matrix source audio, ARC must be turned on or off. Enable or disable ARC through RS-232 (see
page 15) or front panel (see below).
1. Check to be sure the display supports ARC
2. Enable ARC on the HDMI output of the matrix through RS-232 (see page 14) or front panel
(see steps above)
3. Connect the HDMI Matrix output port to the ARC labeled input port on the display
NOTE: The Matrix must be connected to the display’s HDMI ARC input
4. Connect the source to a non ARC HDMI input port on the display
5. Connect the S/PDIF port to an AVR or Zone Amp
NOTE: The S/PDIF port used must be the same output number as the HDMI port connected
to the display
--->
--->
Audio Return Channel (ARC)
Steps
S/PDIF
HDMI
Bidirectional HDMI w/ARC signal
S/PDIF audio loop-out