BIXOLON SRP-340 - Manual (Page 15)

Rev. 1.02 - 15 -
SRP-340
1-6 Recommended Papers
- TF50KS- E (Paper Thickness: 65μm): Nippon Paper Industries Co., Ltd.
- PD 160R (Paper
Thickness: 75μm): New Oji Paper Mfg. Co., Ltd.
-
P350 (Paper Thickness: 62μm): Kansaki Specialty Paper, Inc. (USA)
※ CAUTIONS
Use of papers other than those recommended above may damage TPH or degrade the
printing quality and our company is not responsible for the damage caused by non-
recommended papers. If you have to use other products, we recommend that you use
papers with a similar level of quality to the recommended ones.
1-7 Adjustments and Settings
The SRP-340 is set up at the factory to be appropriate for almost all users. It does,
however, offer some settings for users with special requirements.
It has DIP switches that allow you to change communication settings, such as
handshaking and parity check, as well as print density.
The SRP-340 also has a near-end sensor for the paper. This can give you a warning when
the paper is almost out. If you find that there is not enough paper remaining on the roll
when the near-end sensor is triggered, you can change the near-end sensor setting.
Rotate the near end sensor tab at front or rear position. (See the below figure)
Near end sensor tab