BIXOLON STP-131 - Manual (Page 5)

Rev. 1.06 - 5 -
STP-131
■ Caution
Some semiconductor devices are easily damaged by static electricity. You should turn the
printer "OFF", before you connect or remove the cables on the rear side, in order to guard
the printer against the static electricity. If the printer is damaged by the static electricity, you
should turn the printer "OFF".
■ Introduction
The STP-131 Series Roll Printer are designed for use with electronic instruments such as
system ECR, POS, banking equipment peripheral equipment, etc.
The main features of the printer are as follows:
1. High speed printing : 23 lines per second.
2. Low noise thermal printing.
3. RS-232(STP-131S Series), Parallel(STP-131P Series)
4. The data buffer allows the unit to receive print data even during printing.
5. Peripheral units drive circuit enables control of external devices such as cash drawer.
6. Characters can be scaled up to 64 times compared to it's original size.
7. Bar code printing is possible by using a bar code command.
8. Different print densities can be selected by DIP switches.
Please be sure to read the instruction in this manual carefully before using your new
STP-131 Series.
NOTE ※
The socket-outlet shall be near the equipment and it shall be easy accessible.
※
All specifications are subjected to change without notice.