Brennenstuhl Solar LED Light SOL 80 plus IP44 with PIR sensor 8xLED 0,5W 350lm Cable length 4,75m Colour white User Manual
Page 10
10
Solar LED lamp SOL 80 PLUS
GENERAL SAFETY TIPS
1. Do not use any other solar module than the one provided. Using another solar module
can cause injuries or damage to the light and termination of the warranty.
2. Lay the cable such that it is secured and cannot create any kind of hazard (e.g. hazard
of tripping). Discontinue use of the solar light if the cable is damaged or defective.
CLEANING
Keep the motion detector free of dust and deposits by occasionally cleaning it with a
damp cloth. Do not use any chemicals or abrasive agents to clean the device. Also, make
sure that the solar module is always free of dirt and deposits. A dirty solar cell cannot
completely charge the battery. This can cause premature aging in the battery and lead to
unreliable function in the device.
STORAGE
Follow these steps if you are going to store you light for more than two or three days
inside, in order to prevent damage to the battery:
1. Set the switch to the OFF-position.
2. Store the light and the solar module where the module can receive either sunlight or
indoor light every day. The battery needs light in order to retain its charge while
stored.
3. During long-term storage, the unit must be completely recharged every four months.
In order to preserve complete and proper performance, do not store it for long periods.
NOTE THE FOLLOWING TROUBLESHOOTING SOLUTIONS:
1. Problem: Light does not activate when there is motion in the monitored area.
Possible Solutions: Make sure that:
- The switch is in the “AUTO” position.
- The LUX-control is not set too far in toward (
).
- The motion detector is set such that movements can be detected.
- The solar cell is aimed so that it can receive as much direct sunlight as possible
during the day.
- The battery’s charge is not insufficient (charge for 3-4 sunny days with the switch set
to OFF).
2. Problem: Light comes on during the day.
Possible Solution: Make sure that the LUX-control is not set too far toward (
).
3. Problem: Light flickers.
Possible Solution:
- Weak battery. Charge the solar light for 3-4 sunny days, during which the switch must
be set to OFF.
4. Problem: The charge level display still hasn’t turned green after 16 hours of charging
using the power supply.
Possible Solutions:
- Check to see if the power supply you’re using complies with the prescribed
specifications.
- Have the battery voltage checked by a technician; it is possible that the battery has
been damaged and needs to be replaced.
012109 Solar LED-Strahler SOL 80_012109 Solar LED-Strahler SOL 80 BA 12.12.12 12:37 Seite 10