CP Electronics VITM6-EBDSPIR-DD - Manual (Page 12)

12
Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.
Dimensions See diagrams opposite
Weight 0.15kg
Supply Voltage 230VAC +/- 10%
Frequency 50Hz
Maximum Load Channel 1 (switching):
10A of lighting and/or ventilation
including incandescent, fluorescent,
compact fluorescent, low voltage (by
switching the primary of transformer).
Channel 2 (dimming):
Maximum number of DSI or DALI
ballasts is 10 unless the relay is
disabled then it is 20.
Power consumption On 625mW, Off 807mW
Dimming output
Basic insulation only. Although low
voltage, this is not an SELV output
and should be treated as if mains
potential. Use mains rated wiring.
Terminal Capacity 2.5mm 2
Temperature EBDSPIR-DD -10ºC to 35ºC
EBDSPIR-DD-IP -10ºC to 35ºC
EBDSPIR-DD-IP-LT30 -30ºC to 35ºC
Humidity 5 to 95% non-condensing
Material (casing) Flame retardant ABS and PC/ABS
Type Class 2
IP rating EBDSPIR-DD IP40
EBDSPIR-DD-IP IP55
EBDSPIR-DD-IP-LT30 IP55
Compliance
EMC-2004/108/EC
LVD-2006/95/EC
Technical data
Part numbers
EBDSPIR-DD
DBB
Part number Description
Detector EBDSPIR-DD Ceiling PIR presence detector – DALI / DSI dimming
EBDSPIR-DD-IP Ceiling PIR presence detector – DALI / DSI dimming sealed to IP55
EBDSPIR-DD-IP-LT30 Ceiling PIR presence detector – DALI / DSI dimming sealed to IP55 -30ºC
Accessories DBB Surface mounting box
UHS5 Programming IR handset
UNLCDHS Universal LCD IR handset
C.P. Electronics Ltd
Brent Crescent
London
NW10 7XR
United Kingdom
Tel:
+ 44 (0) 333 900 0671
Fax: + 44 (0) 333 900 0674
www.cpelectronics.co.uk
[email protected]
IMPORTANT NOTICE!
This device should be installed by a qualified electrician in
accordance with the latest edition of the IEE Wiring
Regulations and any applicable Building Regulations.
Ref: #WD487 Issue 3