CUE Wireless Touch Panel - Manual (Page 17)

17
Wireless Touch Panel | User Manual | Upload User Application
© CUE, a.s. All Rights Reserved. | www.cuesystem.com | [email protected]
Upload User Application
Overview
User control application is dedicated to control and it is programmed by Cue Visual Composer programming
tools.
Using Cue Visual Composer
Steps are
1. Connect touch panel to your computer as described in chapter Setup / PC Connection.
2. Run Cue Visual Composer on your PC.
3. Open appropriate project in Cue Visual Composer. It’s necessary to have appropriated touch panel
properly inserted and configured.
4. Use tool bar button Final to open Upload and Export Application dialog box.
5. Be sure your touch panel is checked.
6. Use button Upload to start application upload.
7. If touch panel firmware isn’t actual it will be uploaded automatically first and then application
upload will be finished.
Using Admin Web
Steps are
1. Run Cue Visual Composer on your PC.
2. Open appropriate project in Cue Visual Composer. It’s necessary to have appropriated touch panel
properly inserted and configured.
3. Use tool bar button Final to open Upload and Export Application dialog box.
4. Be sure your touch panel is checked.
5. Use button Export All... to export application and store it in file *.cvca.
6. Connect touch panel to your computer as described in chapter Setup / PC Connection.
7. Run the Internet browser on your PC and type in the same touch panel IP address as you see in Cue
Visual Composer project, window Properties / IP address.
8. Go to page System and check current firmware version. In case there is no actual firmware version
in touch panel, upload firmware version that corresponds to firmware version in the Cue Visual
Composer project..
9. Go to page Applications and upload application file *.cvca.
10. Start uploaded application using button Start.